Suggested Use

Amber Gel can be used as often as required.

Please note that you do not need any before or after skin care lotions. If you wish you can remove any residue by simply rinsing the area with water or using a wet wipe.

1. You must ensure that the skin to be treated is clean, dry, free from moisturisers, oils, lotions, perspiration etc.
2. Then using the spatula provided apply a small amount of Amber Ge onto the area to be treated. Spread thinly in the direction of the hair growth. (do not be tempted to use more than a small amount and do not drag the applicator on the skin) Amber Ge should melt with the warmth of your own body and glide on.
3. Apply the paper strip onto the area you are treating and firmly press a couple of times along the length of the strip.
4. Now holding your skin taut, pull the strip quickly on the opposite direction of the hair growth (not upwards). You will notice that without pain your unwanted hair will be on the strip with the roots, leaving your skin clean, hair free and velvety soft.
5. Using the same strip and without reapplying further; continue the above no. 3 and 4 until the strip no longer holds onto the skin. You will find that with just one strip you can remove quite a lot of unwanted hair without reapplying the gel.
6. After completing your treatment you can wash the applicator and strips under a cold tap and dry them to use next time.

Please note that this is the method to adopt to treat hair in any part of your body. Do not use on cuts, chapped, broken, irritated or sun burnt skin. Do not use immediately following a bath.